Promise Technology VessRAID 1000s Series Manuál Strana 346

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 462
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 345
VessRAID 1000f, 1000i, 1000s Product Manual
326
See page 322, Figure 4.
10. Reinstall the RAID controller.
See “Replacing a RAID Controller” on page 320.
This completes the cache battery replacement procedure.
Replacing the Memory Module
The memory module is a single inline memory module (SIMM) installed on the
main board of the RAID controller. You might replace the memory module as a
capacity upgrade as well as a repair.
To replace the memory module:
1. Shut down the VessRAID and remove the RAID controller.
See “Replacing a RAID Controller” on page 320.
Figure 10.Removing the RAID Controller
A VessRAID 1740i is shown. Other models are similar.
2. Lay the RAID controller on a non-static surface and remove the cover
attaching screws, one on each side, then remove the cover.
See page 322, Figure 4.
3. Gently press the retainers outward until the memory module pops out of the
memory slot.
Cautions
Only a qualified technician should perform this procedure.
You must shut down the VessRAID subsystem before you can
perform this procedure.
Installing the wrong SIMM results in boot failure.
Thumbscrew Latch
Zobrazit stránku 345
1 2 ... 341 342 343 344 345 346 347 348 349 350 351 ... 461 462

Komentáře k této Příručce

Žádné komentáře